|
Kit Includes:
Large Armorer’s Tool Roll
- Denier Nylon Wrap Around Handles
- ID holder -Velcro Closures Inner Protective flap has
- (3) punch or small tool pockets
- (4) Head-Space Gauge pockets
- (1) 4.5" x 5" accessory pocket
- (1) 14" x 5 " open mesh pocket with Velcro closure for other Armorer tools/AR15 part kits
- Main compartment has (12) individual pockets for Standard Armorer's tools which are protected by the inner flap further securing the tools using Velcro® closures
Small Punch Roll 15.5"l x 5.75"w
Plus:
- 1/8” Roll Pin Punch – removes the trigger guard roll pin, drifts out the hammer and trigger pins
- 3/32” Roll Pin Punch – removes and installs the forward assist
- 1/16” Drift Punch – removes the A2 rear sight windage drum, gas tube, collapsible stock lock nut and charging handle latch
- 1/8” Roll Pin Punch – installs the trigger guard roll pin
- 1/16” Roll Pin Punch – installs the gas tube toll pin, A2 sight windage roll pin, the charging handle latch roll pin and the collapsible stock adjustment nut roll pin
- AR-15/M16 Catch Pin – installs & removes roll pin that holds the bolt catch in place
- 1/8” Roll Pin Holder – makes it easy to install roll pins
- 3/32” Roll Pin Holder – makes it easy to install roll pins
- 1/16” Roll Pin Holder – makes it easy to install roll pins
- CAR Stock Wrench – removes the castle nut on a collapsible stock
- Multi-Tool – removes an A2 stock screw, A2 lower receiver extension, standard barrel nut, and flash hider, and removes the old style CAR stock locking nut
- Handguard Removal Tool – removes the handguard
- ¾” Plastic/Brass Hammer
- A1-A2 Front Sight Post Tool – adjusts front sight post
- Flat Bladed Screwdriver – removes the pistol grip on mil spec AR
- Receiver Push Pin Tool –pushes the front pivot pin and the rear take down pin. Also offers a hole to install the front pivot spring & detent
- Carbon Scrapper – removes carbon from inside the bolt carrier
|
